Model:7PE200
PoE Splitter

Overview

The PoE Splitter splits a networked PoE Signal into separated power and Gigabit data sources. This device allows administrators to run Fast Ethernet speed PoE cables over long distances and then split the PoE signal into separated data and power sources in order to network non-PoE devices. Active splitters are aslo available in the following output voltages (5V or 9V or 12V).

Save installation and equipment cost when installing 802.11n access points, (Pasn/Tilt/Zoom) IP cameras and more in remote locations. No need to install network devices near a power outlet. This compact device safeguards valuable network equipment with short circuit protection and quickly creates an integrated PoE and non PoE network at Gigabit speeds.

Features

  • - Network devices at fast ethernet speeds all within a compact device
  • - Automatically detects PoE terminals and supplies inline power
  • - Easily install non-PoE devices where a power outlet is not availabled
  • - Reduce installation and network equipment costs
  • - Safeguards network device with short circuit protection
  • - Adjustable output DIP switch for 5V, 9V, and 12V adjustable output
  • - Converts Non-PoE devices with Power Over Ethernet Support
  • - Auto-sensing power drawn from 802.3af power source equipment(PSE) devices
Requlatory 802.3af
Data Rate 10/100M
Input Power Voltage DC 48V/0.3A
Output Power Voltage 5V(2A), 9V(1.1A), 12V(1A)
Input Power Requirement 1/2(+) 3/6(-) or 4/5(+) 7/8(-)
Diagnostic LEDs DC Power is Green
Jumper Cable DC 2.1*5.5*9.5mm (L-300mm)
Connectors Shielded RJ-45, EIA 568A and 568B
Temperature Operating: -10 ~ 45 ℃
Humidity 10 ~ 90% (Non-Condensing)
Dimension 80 (L) x 55 (W) x 31 (H) mm
Weight 76 g
Home :: Products :: Site Map :: Contact :: Legal Notices
Copyright © 7inova ., All Rights Reserved